We only need to look at the packaging to notice Shurtape doesn't recommend creating an outline. However, it's not the way Shurtape recommends using its product.
#Shurtape carpet tape how to#
We'll include a few videos showing you how to use the tape.Īn outline is a simple way to anchor the rug without too much tape. Of course, a guide wouldn't be complete without some visual demonstrations.
Instead, you can choose whichever method you prefer. You don't have to worry about doing this job incorrectly there is no correct way. Now your rug should stay in place no matter the amount of movement. Once the entire thing is on the floor, press firmly on it. Still, it doesn't hurt to set it in place carefully. Since you already have the tape on the backside, the final step is to lay it down. It takes the guesswork out of the equation. The manufacturer's method is the best way to avoid wrinkles and dents. Press down on the rug to help the adhesive get a good hold. After enough straightening, remove the liner on the tape on one side. If you haven't removed the liner, stretch the rug over the outline. This way, the rug can attach to the liner side. Then, slowly roll it out on the tape apply pressure as you go. If you're applying the rug to an outline on the floor, start by rolling it up. For this reason, your best option is to place it in sections. You'll need to set it down carefully to avoid dents and wrinkles. Laying the RugĪ crucial part of the process is laying the rug. You could straighten it out, but the tape's adhesive will interfere with the process. Otherwise, the rug will end up with wrinkles. Of course, you'll want to be careful with this method. Then, once the tape is in place, remove the liner and lay the rug/mat on top. The other way to do it is by outlining where the rug will sit. After applying the tape, set it on the floor. If you want to follow the manufacturer's instructions, you can remove the liner and apply the liner side to the rug. There are a couple of ways to go about making an outline. The surface must be clean and dry for the tape to work correctly. We will use these pieces to make an outline.īefore putting the outline together, clean the surface. Using the Tape To Create an OutlineĪfter taking the measurements and making cuts based on those measurements, you should have four pieces of tape. If you look at the packaging, one roll of Shurtape Hold-It is enough to hold down a 3 ft x 5 ft rug. In addition, make sure you have enough for your rug. In other words, someone can accidentally trip on it if they're not paying attention.įor this reason, it's better to apply the tape to all sides. However, that means one side will be loose. Of course, two pieces of tape should be enough to hold down the rug. So, take a tape measure and note the length and width of the rug. You can start the process by measuring the dimensions of your rug. We'll share more information you might want to know. If you'd like to cover each step in detail, keep reading. This way, you can have a stress-free experience. Nevertheless, it never hurts to learn how to use it first. It isn't tough to use Shurtape's rug tape.
If you'd like to learn how to use it, we've made a step-by-step guide! Fortunately, Shurtape Hold It tape is one product you can use for this situation. At that point, you're ready to use anything to hold it still. Rugs are a welcome addition to most homes, but they're usually hard to keep in place.
0 kommentar(er)
